Default welcome msg!

0 items: $0.00

Call Us: 989-430-7622

Thank you for making your hobby an Air Hobby.

Search results for 'Syma X5C 4 Channel 2.4GHz RC Explorers Quad Copter w/ Camera'

Maximum words count is 10. In your search query was cut next part: Camera.

Items 1 to 12 of 76 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Grid  List 

Set Ascending Direction
  • Dualsky 5A Voltage Regulator/ UBEC

    Dualsky 5A Voltage Regulator/ UBEC

    This linear voltage regulator is can handle up to 30W output. We recommend this unit on small to .50 size airplanes, boats and helicopters. It has a small LED that illuminates when power is supplied.



    • Output:  5-6V adjustable, 5A Max, 30W

    • Ripple:  <20mV

    • Input:  6-8.4V, 10V Max

    • Size 2.5 x 1.25 x .35 inches

    • Weight:  27g

    • Connectors:  Futaba female for input, JR male for output, Failsafe switch connector

    • Controls:  Potentiometer for output adjustment

    • Indicators:  Green LED on when powered

    Regular Price: $22.99

    Special Price $19.95

  • Cozort Spektrum Flight Pad

    Cozort Spektrum Flight Pad

    Relax while flying! These transmitter trays will help relieve stress on your wrist and fingers while flying! Let the tray do the work for you!


    These trays are machined in the USA and will last longer than the plane!


    They fit Spektrum radios. Installation is easy!


    These do not include a neck strap, and you need the neck strap strap with 2 clips.


    The tray has 2 sets of holes for the eye bolts; most transmitters use the outer set.  To install the eye bolts, put the bottom lock nut on until it is flush with the end of the eye bolt then tighten the top lock nut. To mount the radio, set the transmitter on the tray.  Place the spektrum handle bar in the metal handle bar clip on the flight pad.  This will lock your radio in place when pressed up against the eye bolts.  You may need to put a slight bow in the tray.  I push down on the top edge of the tray, and bend it a little.



    • This will fit MOST spektrum radios

    • Handle Bolts on Radio to Metal Back bar on Spektrum:  6 3/4 inches

    • Metal clips with hold your JR / Spectrum Transmitter in place

    • Don't forget the Comfort Neck Strap

    • Weight:  8.5oz (with the hardware) 

    • Width:  7 inches at the edge 

    • Length:  8 inches 

    • Color:  Black checkerboard top, white bottom 

    • Material:  Carbon and Plastic

    $37.00
  • Micro Battery Paraboard Adapter (1S LiPos)

    Micro Battery Paraboard Adapter (1S LiPos)

    This paraboard is designed for use with your micro batteries, the 130,150's,180's and small micro batteries.


    To use this connect it to the charger.


    Then set the charger for 1s, 3.7V.


    Then add up the total of the batteries mAh on the charger and use that number.


    For example if you use 4 1s 150 batteries, then set your charger for: 3.7V and (4x150 mAh=600 mAh) 600 mAh.


    Make sure you know the max your charger can do!


    Can charge 6 batteries at one time at 1.5A!

    $20.00
  • Micro Battery Paraboard Adapter (JST LiPos)

    Micro Battery Paraboard Adapter (JST 1S LiPos)

    This paraboard is designed for use with your small batteries using JST connectors.  This board has 6 sets of JST connectors and 6 resettable fuses.


    The melting current of each resettable fuse is 1.25A.  The maximum total charge current equals 1.25A multiplied by the number of batteries.


    The voltage of all batteries should be the same before start up.


    Total charge current (A) = mAh/1000 x C


    For example six 200mAh batteries at 2C would be 2.4A (1200/1000 X2)

    Regular Price: $16.00

    Special Price $11.95

  • 40A Paraboard with T Plug for XH balance connector

    40A Paraboard V2 with T Plug for XH Balance Connector

    This paraboard is for batteries with a XH balance connector and T-Plug type connectors. XH balance connectors are those found on Mad Dog, Dualsky, E-Flite, but NOT Thunder Power! This board can handle a total of 40A flowing through it.


    To use this connect it to the charger. Then set the charger for the voltage of the battery.


    DO NOT MIX 2,3 and 4 CEll batteries. You must use the same cell count on all the plugs.


    Then for the mAh, add up the total of the batteries on the charger and use that number.


    For example if you use 4 3s 2200 batteries, then set your charger for: 11.1V and (4x2200 mAh=8800 mAh) 8800 mAh.


    Make sure you know the max your charger can do. A 50 W charger can charge 6 2200 mAh, 11.1V batteries only set to 4.5A!

    $22.00
  • Gemfan 8045 Slow Fly DJI Phantom 2 piece White Prop

    Gemfan 8045 Slow Fly DJI Phantom 2 piece White Prop

    Gemfan 8045 Slow Fly DJI Phantom 2 piece White Prop
    $1.50
  • Gemfan 8045 Slow Fly DJI Phantom 2 piece Orange Prop

    Gemfan 8045 Slow Fly DJI Phantom 2 piece Orange Prop

    Gemfan 8045 Slow Fly DJI Phantom 2 piece Orange Prop
    $1.50
  • Gemfan 1045 Slow Fly DJI Phantom 2 piece Orange Prop

    Gemfan 1045 Slow Fly DJI Phantom 2 piece Orange Prop

    Gemfan 1045 Slow Fly DJI Phantom 2 piece Orange Prop
    $1.50
  • 40A Paraboard with EC3 Plug for XH balance connector

    40A Paraboard V2 with an EC5 Plug for XH Balance Connector

    This paraboard is for batteries with a XH balance connector and EC5 type connectors. XH balance connectors are those found on Mad Dog, Dualsky, E-Flite, but NOT Thunder Power! This board can handle a total of 40A flowing through it.


    To use this connect it to the charger. Then set the charger for the voltage of the battery.


    DO NOT MIX 2,3 and 4 CEll batteries. You must use the same cell count on all the plugs.


    Then for the mAh, add up the total of the batteries on the charger and use that number.


    For example if you use 4 3s 2200 batteries, then set your charger for: 11.1V and (4x2200 mAh=8800 mAh) 8800 mAh.


    Make sure you know the max your charger can do. A 50 W charger can charge 6 2200 mAh, 11.1V batteries only set to 4.5A!

    Regular Price: $22.00

    Special Price $15.95

  • 40A Paraboard V3 with an EC3 Plug for XH Balance Connector

    40A Paraboard V3 with an EC3 Plug for XH Balance Connector

    Use ParaBoard V3 to safely charge up to 4 set batteries in parallel. The board is protected by resettable polyfuses. Can be used for batteries with JST-XH type balance plug (the most popular type in the market) and EC3 connectors.


    Parallel charge can save your time significantly. If you charge four batteries at the same time, the charge current is four times of that you used for a single pack, and you need only approximately 1/4 of the charge time to charge every battery separately. Similarly, if you charge six batteries at the same time, the charge current is six times and time is only 1/6.


    This paraboard is for batteries with a XH balance connector and an EC3 type connectors. XH balance connectors are those found on Mad Dog, Dualsky, E-Flite, but NOT Thunder Power! This board can handle a total of 40A flowing through it.


    To use this connect it to the charger. Then set the charger for the voltage of the battery.


    DO NOT MIX 2,3 and 4 CEll batteries. You must use the same cell count on all the plugs.


    Then for the mAh, add up the total of the batteries on the charger and use that number.


    For example if you use 4 3s 2200 batteries, then set your charger for: 11.1V and (4x2200 mAh=8800 mAh) 8800 mAh.


    Make sure you know the max your charger can do. A 50 W charger can charge 6 2200 mAh, 11.1V batteries only set to 4.5A!

    $27.00
  • 40A Paraboard V3 with an EC5 Plug for XH Balance Connector

    40A Paraboard V3 with an EC5 Plug for XH Balance Connector

    This is the latest version of ParaBoard with self-resettable fuse protection. The PCB board is made of three ounce copper and the main circuit supports up to 40A current. All the balance ports are protected by resettable fuses (also known as polyfuse), and the main circuit is protected by common car fuses that are easily available at local hardware stores.


    This paraboard is for batteries with a XH balance connector and EC5 type connectors. XH balance connectors are those found on Mad Dog, Dualsky, E-Flite, but NOT Thunder Power! This board can handle a total of 40A flowing through it.


    To use this connect it to the charger. Then set the charger for the voltage of the battery.


    DO NOT MIX 2,3 and 4 CEll batteries. You must use the same cell count on all the plugs.


    Then for the mAh, add up the total of the batteries on the charger and use that number.


    For example if you use 4 3s 2200 batteries, then set your charger for: 11.1V and (4x2200 mAh=8800 mAh) 8800 mAh.


    Make sure you know the max your charger can do. A 50 W charger can charge 6 2200 mAh, 11.1V batteries only set to 4.5A!

    $27.00

    Out of stock

  • Dynamic Foamy F22 Mini profile kit

    Dynamic Foamy F-22 Raptor Mini 16" Wingspan

    The F22 Raptor Mini was designed for the highest performance, and at 2.5 - 3.5oz it delivers. The design allows for super slow high alpha flight while maintaining adequate control. Open the throttle and this bird handles the outdoors just as well. The kit features laser cut interlocking depron foam parts for easy assembly. The model balances dead on with all of the gear and equipment hidden within the lower fuse. And is true to scale.


    Foam: Depron 2mm Painted


    Wing Span: 16 inches


    Length: 23 inches


    Weight RTF: 2.5 - 3.5oz


    Motor: Park 180, 7 - 10g


    LiPo: 250 mAh 2S


    Servos: 3g x2


    Prop 4040

    $37.00

Items 1 to 12 of 76 total

per page
Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5

Grid  List 

Set Ascending Direction